G.M.K Team
G.M.K Team
شرح برنامج FLYCCCAM بصورة مع تحميل اخر اصدار
A new Version from FLYCCCAM v0.4 has been issued dated 17/10/2009
A new Version from FLYCCCAM v0.4 has been issued dated 17/10/2009
and here is the announcement from the site
It is mainly as previous versions with little changes
Sharing CCCam is mainly one line server or many lines servers
We put this (These) server(s) in a file called flyccam.cfg
using the NotePad of windows
We put this (These) server(s) in a file called flyccam.cfg
using the NotePad of windows
After putting the server(s)
We start the program from a file called SSSP Plug.exe
and it is located in the main folder
then comes the advertisement scrren
and we close it
the the Monitor appears
We start the program from a file called SSSP Plug.exe
and it is located in the main folder
then comes the advertisement scrren
and we close it
the the Monitor appears
Then we start the program and press CONNECT
the program will start and get the code
and we notice the Monitor and the code it brought
And in case the Monitor did not appear
You can show it yourself
the program will start and get the code
and we notice the Monitor and the code it brought
And in case the Monitor did not appear
You can show it yourself
It has to be noted that
the preparation in the Config page of the Humax 5400 is
Card+S+Emu
Ecm+Emm
SSSP
And you can use any software (Firmware) as you like
Starting from 7.5 till 11.1
Starting from 7.5 till 11.1
I hope you keep Enjoying Humax 5400
Best regards and wishes
Best regards and wishes
the program is Attached
patch FLYCCCAM
:download:
